P
partial
Guest
OK, so this thread is probably odd coming from me.
Let me start off by saying, I cannot edit frqs because I don't know how to do it properly, so I always record my vbs very quietly. I found an old vccv of mine from 2015, with the volume of the wavs at a more average level, and the voice that bank creates is much less robotic and much more natural. It's quite glaring and very problematic to me that this bank I've been working hard on sounds worse than my first voicebank.
Here's a sample comparing that 2015 vccv to the vccv I've been working on. Rendered with moresampler for both banks.
Here is a comparison of a few oto configs, so you can see the difference in volume.
You get the idea.
The reason I started recording as I do now is because I don't run into frq problems, but I just realized the quality I've sacrificed.
Does anyone understand how to use this frq editor? I can't use the editor built into UTAU, as the buttons at the bottom get cut off by the edge of the window.
Let me start off by saying, I cannot edit frqs because I don't know how to do it properly, so I always record my vbs very quietly. I found an old vccv of mine from 2015, with the volume of the wavs at a more average level, and the voice that bank creates is much less robotic and much more natural. It's quite glaring and very problematic to me that this bank I've been working hard on sounds worse than my first voicebank.
Here's a sample comparing that 2015 vccv to the vccv I've been working on. Rendered with moresampler for both banks.
Here is a comparison of a few oto configs, so you can see the difference in volume.
You get the idea.
The reason I started recording as I do now is because I don't run into frq problems, but I just realized the quality I've sacrificed.
Does anyone understand how to use this frq editor? I can't use the editor built into UTAU, as the buttons at the bottom get cut off by the edge of the window.